Thanks for the help stove is up and running,the only problem is to start stove I have to do the candle trick otherwise stove won't heat up it shuts down. not sure the cause of this? On the igniter I'm not sure what white wires you're talking about switching.Are these the J-4&J-6 on the mother board? Thanks again for you're help, glad to have stove running with cold weather on the way

they are j5 and 7 on small board

Look on the smaller board for j5 & 7 like Blume says. They are right next to each other and have hold-down clips on the sides. White in color. If you have a ohm meter test for continuity. Sometimes the pins and wire didn't get a good connection so check that. If that is the case you can use a finishing nail to reopen the pin then crimp it.
I don't know why that thermocoupler acts the way it does. If it works holding a candle under it I would think it should work in the stove.

could be a bunch of ash up in manifold blocking heat to t/c, have to take fan cover off and run a brush up there make sure t/c is not hit, 110's get bad up there

Not really sure what happened, stove cycled for the ash dump and the lights on the board for a bad igniter turned off . stove has been running all day. And again thanks for your help

lights will go out after ash dump but still has bad igniter

blume seems my left igniter is not working ,rona says you have some available was wondering if I should replace them both while i'm replacing one.

Switch the left and right around on the board and try them again. sometimes its a bad fuse. Or use a ohm meter that will also tell the story. I would replace both and use the remaining one as a spare. Make sure you use the new fuses he sends along.

not sure what I'm switching ,what do the wires look like? is it on the sister board ?
Thanks

Yes they are on right side of the smaller board or sister board as you refer to them. one right above the other. easiest is to find the wire with white flex tube on each side of stove going to each igniter and track them back to sister board. They can be black or white wires and have a white double wire connector on the end that clips onto the board. Simply squeeze the sides to disconnect from the board.