Welcome, Guest

Hello out there and Merry Christmas
(1 viewing) (1) Guest
  • Page:
  • 1

TOPIC: Hello out there and Merry Christmas

Hello out there and Merry Christmas 4 months, 3 weeks ago #16947

  • scatpac1
  • OFFLINE
  • Newbie Burner
  • Posts: 6
  • Karma: 0
I have a Mount Vernon stove, I have a question if Yall could please help, sometimes during the autoclean cycle the pot sticks when its sliding back and forth on the tracks, is there a special or good lubricant any of you recommend to keep thisfrm happening, or any suggestions? thank you all in advance, and a properous new year.

Re: Hello out there and Merry Christmas 4 months, 3 weeks ago #16952

  • kappel15
  • OFFLINE
  • Expert Burner
  • Posts: 968
  • Karma: 23
Hi scatpac1 and welcome to the forum. You can put some high temp anti-seize grease on the rails with a Q-tip. Use it sparingly. Also, carbon deposits will build up on the pot floor, that will catch. You need to scrape them off. Also, what number control board do you have, and what year stove? In 2008, they came out with a new board with the powerstroke code added as the auto-clean motor didn't have enough power on the return stroke, to close sometimes. Also if it is not closing all the way, the auto-clean motor mount bolt can work loose. Pull ashpan, and it is on back wall. Kap
QuadraFire
Trained Tech.
Sante Fe
Mt.Vernon AE
Kan-Burn Shur-KleenII Kapkleaner
Last Edit: 4 months, 3 weeks ago by kappel15.

Re: Hello out there and Merry Christmas 4 months, 2 weeks ago #17106

  • scatpac1
  • OFFLINE
  • Newbie Burner
  • Posts: 6
  • Karma: 0
thank you Kapp, I cleaned the build up,lubed it with some high temp anti sieze and its all good..thanks again..
  • Page:
  • 1
Time to create page: 0.99 seconds
Best free joomla themes