I fired up the Rev last night and it loaded and pellets and lit fine. When it came to the hopper "A" auger to start, it appeared to start so I filled the hopper with pellets. shortly after the fire was out and the number one lite was flashing. I found no reference to the #1 lite in the manual. This morning I went back down and emptied the hopper and fired the furnace up and watched the initial feed from hopper "B" and then when hopper A was called to start, it would just move a little and stop but didnt go anywhere. Since it looks like there might be a jam up in the auger tube My question is how hard is it to remove the auger andare there any surprises I should be on the look out for? Also, what is the gasket made of on the motor flange? Ive cleaned all I could see and reach with a peice of wire. It will try to move but actslike its binding.