Auger jam has been fixed. Wasnt sure if there were any surprises like a spring or small part to fall out. However, Any tips on removing the scraper so I can get the rod tack welder. Health is not good so as little time that I have to spend on it would be great. Hate asking for help.Looks like I can take the whole right side but not sure what is beyond that.

Wow...I feel bad. Nobody seems to have any experience with your situation. Hang in there and keep checking back. Someone may pop in with some helpful advice.

I dont know if this will help at all but you could look at the service manual.
stcroixstoves.com/pdfs/Furnace%20Manuals...lution%20Manuals.pdf

I got it taken care of, Just wasnt sure of what might pop up. I have the manual with parts list but I have manuals were it doesnt tell you thater might be a clip on the other end of a shaft or in this case an auger. Still waiting on the proper procedure to a get the scraper out to weld the rod back on but exploring other options to get by with it. The SF50 rev is a pretty basic build but I would a hate to get it apart and find that it wont go back the way it was. Also ran down some old post on the old forum and got some answers. Luckily my auger issue was a as simple as a pellet jam.