Im in need of a primary control board (011350S) and a manual reset switch(F000105) for a GBU070 Trager corn furnace. I've found them on the Pinnacle web site any one know of a cheaper source?
Thanks

You are correct it is a GBU070 furnace.It has an old Honeywell mercury wall thermostat hooked to it on two wire thermostat wire. I agree that it is running correct until it reaches the desired temp. in the house and it just keeps running corn in, when i believe it should kick out and run on pilot? The furnace itself has no thermostat setting that i can see. It has three switches pilot cycle time, off/draft/and feed, and pilot fan speed.

When the room thermostat reaches the desired temperature it is not going into pilot mode ...

Not quite sure how this site works, but here is my problem. I bought a used 011350S Traeger furnace from a friend. I've installed it and when I fire it up it kicks in and runs when I turn the thermostat up, but when it reaches the temperature the thermostat is set at the auger and feed cup motors just keep running and the temperature keeps rising! The light on the side blinks when it reaches the set temp. so its my understanding that its going into pilot mode. Anyone got any ideas?? Any help would be appreciated!