 |
I got a bag today so I'll keep u informed.
Thanks again
|
Vacuum switch?
|
Posted 5 months, 1 week ago
by fishalbuq
|
|
|
Kap, I appreciate u checkin back on me. I checked the pot all seems to shut and seat fine, have tried all options with flame height and fuel. Still overfeeds. Not sure what fire pot tc means. Any further words of wisdom.
|
Vacuum switch?
|
Posted 5 months, 1 week ago
by fishalbuq
|
|
|
Cleaned the stove, turned the flame down all the way and pot is still overfilling. Lites up burns and looks good then slowly overfeeds till pots almost full. How can I adjust the feed.
|
Vacuum switch?
|
Posted 5 months, 1 week ago
by fishalbuq
|
|
|
Turned the flame height all the way down and still feeds too much. What next?
|
Vacuum switch?
|
Posted 5 months, 2 weeks ago
by fishalbuq
|
|
|
I recently replaced the auger assembly on my mt.Vern ae and thought that was gonna fix it. I then got a vac switch error. I jumped out the switch and it starts and runs but it continually feeds and eventually fills fire pot overful. Is this controlled at all by the vac switch?
thanks
Wade
|
Vacuum switch?
|
Posted 5 months, 2 weeks ago
by fishalbuq
|
|
|
Kap, thanks again. I'll try the sensor and see what happens.
Wade
|
mt.vernon problem
|
Posted 6 months, 1 week ago
by fishalbuq
|
|
|
Kap, I appreciate the info. I have had a service guy here several times so it has been messed with. A couple different guys has come out and nobody has gotten it fixed, so I'm trying to get it done myself. If I got the whole auger assembly should that fix my sensor alignment issues? I really think this is where the problem lies.
Wade
|
mt.vernon problem
|
Posted 6 months, 1 week ago
by fishalbuq
|
|
|
I have checked all the wiring. Im kind of getting the feeling its in the sensor adjustment or the shaft disc. How do i go about adjusting or setting these?
|
mt.vernon problem
|
Posted 6 months, 1 week ago
by fishalbuq
|
|
|
The motor does reverse as if jammed although its not. The set screw is tight on the auger shaft, but im not sure how to adjust the optical switch. the board is the 456-revc.
|
mt.vernon problem
|
Posted 6 months, 1 week ago
by fishalbuq
|
 |
My Mt.Vernon keeps coming up with the auger jammed error on startup. I have changed the feed motor 2 times and cleaned the optical switch. cant figure it out. I do have the newer board any suggestions? thanks for your help in advance.
wade
|
mt.vernon problem
|
Posted 6 months, 1 week ago
by fishalbuq
|
|
More |
