dealers were a big problem, most were in it for quick buck, know none left around east, but me, we never used junk pipe, had very little problems with our customers, igniters were another problem but i have good ones

i think i'll burn corn till there isn't any anymore, almost fun keeping bixby running for 8 years, 1 feedwheel motor total repairs , got to be willing to learn, 7.00 corn still better than 3.75 oil(1 bu corn = 3 gal oil)

2-3 is running lean, all lights flashing is thermostat satisfied or bad connection on panel with trim pots jumper loose?

can be reached anytime 7177765237 i have fans for less

there is a high temp cutout in fans that is not replacable, have to replace complete fan,
fan would not have anything to do with burn, make sure you didn't move trim pot adj and that feed wheel is not raised

great deal for somebody

i have gaskets

there are 2 bushings in fan, you probably cant buy, or even fet fan off shaft without a lot of work. we have taken off by welding nut to fan then pushing off, better to replace, i have

sounds like brgs

no 6 light is usually ex fan sensor, if fan runs ok hot wired

i have been using brgs that i repace with electric motor grease, also some sealed, from same supplier no problems with any as far as i know
could be fan just running hot, i have new fans too

may have bumped enough for element to go back together, , bump it around with ohm meter connected see if it stays

i would check for dirt under feed wheel

make sure feed wheel seal is ok, also gasket under top plates, maybe try different pellets, switch on wood?

there is a person selling boards on ebay, claming he don't know what they fit, they are for a 100 only save your bucks

the only place to get is from Mike at bixbystoveparts.comm

i would think it needs adjusted, it should click with just pulling handle down and up

got something plugged in wrong, should hear switch make when just loosening door handle, have thermocouple on j18? (main board), or white cable one 1 pin off

shouldent matter, ign stay on even if ligted

does the new laptop have a 9 pin serial port, if not you will need an adapter, give me your address ,i will send cd with programing