Installing a Draft Control Gauge
Last Updated on Tuesday, 16 November 2010 02:24
A video of the installation of a draft control gauge and draft control on to my Traeger TPB-150 boiler. This was done because I felt (correctly as it turns out) that the draft up the chimney was way too high. This caused much of the boiler heat to bu sucked out the chimney.
Adobe Flash Player not installed or older than 9.0.115!
Set as favorite
Email this
Feed
Hits (3163)
This content has been locked. You can no longer post any comments.
You must be logged in to post a comment. Please register if you do not have an account yet.
Paypal Donation
To make a donation to this site, click the button below.